A metal roof system’s life expectancy is second to none when it is properly installed. But like all roof systems, regular maintenance and repair are necessary. Repairing can sometimes be a miss proportion or hit. Repair can outlive the roof system itself if done properly. 

Metal Roof System

Some repair can continue to fail and break if not done properly leaving you with a continual leak condition. Mold growth and interior damage are some of the effects of a recurring leak condition. To ensure your solution provides a watertight roof system for a long time, it is best to fix the problem the first time it occurs.  

It is sometimes difficult to repair the surface of a metal roof system. Cracking, splitting, and ultimately failure of the patch is caused by the difference contraction and expansion between two products. 

If you have a hole in your metal roof and experience a recurring leak, then here are some ways that can help you fix the hole in your metal roof system. 

    Clean the Repair Area 

A number of sources can be the reason for the hole. It may be from deterioration and rust, or from something falling on your roofs, such as a big branch or stones. The hole is most likely dirty thus it needs cleaning prior to repairing. 

Clean the surface of the roof panels until algae and dirt are completely removed. The integrity of the roof repair might be compromised if any residue remains. Use a wire brush to scuff the surface where the repair will be done after cleaning the surface of the metal panel.  The sealant will bond to the metal when you scuff the surface. 

     Measure the Repair Area and Cut a Patch 

The metal sheet must be cut to a size that is equal to the area to be patched. The sheet metal must overlap by at least 2 inches around the edge of the damaged area. Round the corners of the patch to prevent any sharp corner from becoming a catch for ice or snow after the metal sheet patch has been cut and fit to size. 

Place the patch over the hole being repaired once it has been measured. Remove the patch and make sure that 2 inches overlap is maintained in all directions past the leading edges of the hole.  

    Install, Repair and Secure the Patch 

Staying just inside the marked pencil line, apply the sealant to the surface of the metal being repaired. The sealant must be applied liberally so that there are no voids or gaps at the leading edge of the patch. Press the patch into the place and apply a little more sealant to eliminate the gaps.  

Attach the patch to the surface of the metal roof panel once with the use of a pan head sheet metal screws once the patch has been pressed in place. It is necessary to retool the sealant that is bleeding over the edge of the patch after it has been attached to ensure that it properly seals the leading edge of the patch and prevents moisture from getting inside. 

If the leakage continues, then you may consider calling for professional help. There are a variety of roofing companies that can assist you such as roofing companies Colorado Springs that offers high-quality work and ensures customer satisfaction.